Climate Technologies multi-appliance Comfort Control Owner's Manual download pdf (Page 12)

Multi-Appliance Comfort Control

Page 12

Ducted Reverse C

cle

Congratulations on purchasing this Bonaire Ducted Reverse Cycle Air Conditioning system, an exciting

new product offered by Climate Technologies.

Bonaire Ducted Reverse Cycle Air Conditioners are designed and constructed for the harsh Australian

climate offering unsurpassed efficiency and durability.

Your air conditioning unit is supported by Climate Technologies, Australia’s most advanced manufacturer

of a complete range of climate control products.

To ensure you fully enjoy the benefits of this Ducted Reverse Cycle Air Conditioning system, please read

these instructions carefully and keep them handy for future reference.

If operated and maintained in accordance with this manual, this unit will provide you with years of comfort

and reliability. Please take the time to read this manual.

NOTE: As a responsible corporate citizen the manufacturer, being Climate Technologies, respects

the OHS&W laws of this country and abides by them. In doing so, our service providers reserve

the right to refuse service unless safety and accessibility to the unit can be guaranteed in

accordance with the installation instructions and Australian Standards. The cost of any extra

equipment required to provide access to the unit for servicing is the responsibility of the owner.

GENERAL INFORMATION.

IMPORTANT NOTICES!

• If an appropriately qualified and licensed person is not used to install the equipment or if it's not

installed according to the guidelines, then Climate Technologies will not accept responsibility for any

problems, which occur as a result.

• This manual should be considered as a permanent part of the air conditioning equipment and should

remain with this equipment. It should be read and understood by any persons that will be operating

the system.

NOTE:

This operation manual must be carefully read before operating the air conditioner. If further

information or details and data are required, please contact your Bonaire dealer.

• Climate Technologies pursues a policy of continual improvement in design and performance of its

products. The right is therefore reserved to vary specification without notice.

• Climate Technologies cannot anticipate every possible circumstance that might involve a potential

hazard.

• This air conditioner is designed for standard air conditioning use only. Do not use this air conditioner

for other purposes such as drying clothes, refrigerating foods or for any other similar heating or

cooling processes.

WARRANTY

Warranty service work must only be carried out by Climate Technologies service division or its authorised

service providers. See warranty section.

DATA LOCATION

Your appliance model number, serial number and model description are located on the appliance data

plate on the side of both the indoor and outdoor units. These details should also be in the warranty section

of this booklet.

You will need this information, should your appliance require servicing, spare parts or just if you require

additional information about this product.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 39 40

Comments to this Manuals

No comments

Climate Technologies multi-appliance Comfort Control Owner's Manual Page 12

Comments to this Manuals